Services
What we do
The full range of work this fabrication shop takes on.
Everything we do
Laser and plasma cutting
Sheet and plate cut to your DXF, from thin gauge to two inch plate.
Forming and rolling
Press brake forming and plate rolling for brackets, enclosures and curves.
Certified welding
MIG, TIG and stick in steel, stainless and aluminum, to code where required.
Structural steel
Beams, columns, stairs, platforms and railings, detailed and fabricated to spec.
Custom fabrication
One-off frames, carts, guards, tanks and machine bases built to fit.
IN DETAIL
Pick a service
Sheet and plate cut to your DXF, from thin gauge to two inch plate.
Press brake forming and plate rolling for brackets, enclosures and curves.
MIG, TIG and stick in steel, stainless and aluminum, to code where required.
Beams, columns, stairs, platforms and railings, detailed and fabricated to spec.
WHO WE WORK WITH
RATES
What things cost
| Service | From | Typical turnaround |
|---|---|---|
| Laser and plasma cutting | $00 | 0 days |
| Forming and rolling | $00 | 0 days |
| Certified welding | $00 | 0 days |
| Structural steel | $00 | 0 days |
| Custom fabrication | $00 | 0 days |
Questions
No. Drawings speed things up, but a sketch with dimensions, a photo of what you need to fit, or a site visit is enough for us to detail the job and send shop drawings for approval.
The laser cuts sheet and plate up to two inches in steel and thinner in stainless and aluminum. Heavier plate goes to the plasma table.
Yes. Welders are certified to the relevant structural and pressure codes and procedures are documented, so work that needs a stamped weld inspection can have one.
Yes. Stairs, railings, platforms, guards and equipment bases are usually installed by our own crew, and we coordinate with the site.
Not sure what you need?
Describe the problem and we will tell you which service fits.
- A straight answer
- No obligation
- Fixed quote